HOW WE USE COOKIES:
We use cookies and similar technologies to improve our website, to personalize website content to you, and to deliver advertising messages and offers on content that are relevant to you. For more specific information on how we use cookies and to change your cookie preferences, see our Cookie Notice. Understand and don’t want to see this message again? Click the X to close this notice.
HOW WE USE COOKIES:
We use cookies and similar technologies to improve our website, to personalize website content to you, and to deliver advertising messages and offers on content that are relevant to you. For more specific information on how we use cookies and to change your cookie preferences, see our Cookie Notice. Understand and don’t want to see this message again? Click the X to close this notice.
Rated 2 out of
5 by
pmccarthy from
Don't use the operating instructions!Threading 1 1/2" black pipe is difficult when following the directions that come with the threader. When following the directions, we have broken the cam release lever by the second day of using it. Not following the directions, we have to cut several times over the same section, each time moving the workholder. If setting on "std" (or even close to 'std") first cut, can't get die on to pipe, No assistance available since it is an older mode (and low end of their equipment)l, DON"T BUY IT